Welcome To b2b168.com, Join Free | Sign In
中文(简体) |
中文(繁體) |
Francés |Español |Deutsch |Pусский |
| No.13676740
![](http://i.b2b168.com/e/tag_pthy.gif)
- Product Categories
- Friendly Links
Information Name: | [Raj] FRP fan FRP axial fan noise |
Published: | 2015-05-13 |
Validity: | 365 |
Specifications: | Optional |
Quantity: | 1000.00 |
Price Description: | |
Detailed Product Description: | T35-11, BT35-11, FT35-11, FBT35-11 series axial fan First, the scope and purpose: T35-11 (T40-11) series axial fan is the eighties T30- 11 on the basis of new fans improved design Compared with T30-11 fan has obvious advantages: ◆ ◆ structure is more reasonable performance has improved greatly, the total pressure effect was 89.5%. ◆ lower noise, noise (sound level than A) reduced 3.6dB (A). This series of fans for conveying flammable non-corrosive gases, ambient temperature must not exceed 60 ℃. Widely used in general factories, warehouses, offices, residential heating ventilation or strong heat, but also in a longer interval between the exhaust pipe installed in series to increase pressure in the pipe, remove the fan motor to do free. Corrosion axial fan (FT35-11 type) coated with epoxy paint anti-corrosion materials processing, electrical motors using special preservative used to transport corrosive gas. Explosion-proof axial fan (BT35-11) type, for gas transport flammable and explosive. Impeller machining of aluminum alloy, in order to prevent sparks during operation, the motor with explosion-proof motor. FT35-11 type and BT35-11 type fan performance parameters and dimensions are the same as T35-11-type fan. Fans need to take the stand foot and motor voltage when ordering please. Second, the wind turbine installation instructions: 1, the installation should be carefully checked for damage deformed fan, if damaged deformation, to be repaired properly before installation. 2, pay attention to check the fitting of each coupling portion loose leaves and duct clearance should be uniform, not touching. 3, the weight of the pipe connecting the outlet should not be borne by the fan duct, the installation should additional support. 4, the fan must be installed in the concentrator outlet end device, and install protective nets. 5, the fan base must naturally engage the ground plane, can not beat the end of compulsory connection to prevent deformation of the base, the installation should be corrected base, plus horn pieces, horizontal position, and then tighten the bolt. 6. After installation, you must first test case, to be functioning properly before allowing the official use. |
Admin>>>
You are the 12488 visitor
Copyright © GuangDong ICP No. 10089450, FRP Co., Ltd. Hebei RAJ All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility
You are the 12488 visitor
Copyright © GuangDong ICP No. 10089450, FRP Co., Ltd. Hebei RAJ All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility